Track & Ring Pull-Behind Wheel Kit, Powder-Coated Red

SKU: WHEELKIT

The pull-behind wheel kit allows track and ring conditioners to be pulled behind large garden tractors, ATVs, cars, trucks, and gators. They can be used with either large or small arenas, tracks, courts, courses, and rings.

Track & Ring Pull-Behind Wheel Kit, Powder-Coated Red

The pull-behind wheel kit can be purchased separately if you already have a pre-existing track and ring conditioner. This kit is easy to operate and maneuver with something as small as an ATV and allows for easy travel over grass or driveways. This kit comes with quick draw pins for fast and easy installation on a track and ring conditioner. This kit is adjustable depending on your hitch height and can also be used to adjust the height of the blade.

Kit Includes:

1, Pull-Behind Wheel Kit
Installation Hardware
Installation Instructions

Installation: The pull-behind wheel kit is crated and boxed when shipped. Easy-to-follow instructions (see steps 8-9) and a complete hardware package allow anyone to assemble it in less than an hour! *Note: This kit does not include the track and ring conditioner.

Step 8 - Assembly of the Pull-Behind Tow Hitch
1. Remove the nuts and lock washers from the lift pins where the S-shaped hitch brackets attach to the A-frame.
2. Carefully slide them out until they are flush with the inside of the S-brackets.
3. Place the hitch arm between the S-brackets and replace the nuts.
4. Attach the top link to the top of the 3 point hitch FIG 8A.
5. Lift the hitch arm up and connect it to the other end of the top link with the hitch pin FIG 8B.
6. In order to adjust the top link, you need to insert the adjusting pin in the hole in the center of the top link and firmly tap it through with a hammer.
7. Adjust the top link until the hitch arm is parallel to the A-frame.
8. Using the 1/2” x 4-1/2” bolt and lock nut, attach the adjustable tow arm to the end of the hitch arm at the required height for your tow vehicle.
Step 9 - Assembly and Mounting of Wheel Assembly
1. Mount the wheels on the axles with grease nipples to the outside and tighten the nuts.
*Note: Remember to grease the wheels periodically. Next, attach the wheel assembly to the mounting bracket that is welded to the end of the A-frame with the two 1/2” x 1-1/2” bolts and locknuts.
*Note: The wheel assembly is used to raise the blade off the ground to prevent damage to the blade when traveling to and from your track or ring or anytime you are traveling over rough ground.
*Note: If using the wheel kit on an existing track and ring conditioner, position and securely clamp the wheel assembly in place and drill a 1/2” hole through the mounting bracket hole and A-frame at 3” from the back of the A-frame.

Shipping: This item ships on a semi-truck via an LTL freight carrier. Please contact one of our expert account managers at 800-434-6296 for a shipping quote. For more information on how this type of delivery works and what we need you to do upon arrival, please read through these two links:

Write a Review Read All Reviews

- "The track and ring conditioner is a perfect drag for just about anyone. It's very easy to hook up and it does an awesome job. The best part is, is that it was half the cost of others on the market!"